First of all I do not appreciate you adding your made up cubit value of 20.618034 inches to my drawing in an attempt to make it look like these are my cubit values. All my drawing should only have inch values on them as this is what Petrie used for his measures.

Second IMO you seem to reject Petrie’s G3 average side measure of 4153.6 inches at times but now you are using Petrie’s measure for G3. So to me it seems dishonest for you to switch to other G3 measures when it fits your convenience.

So please in the future do not post any drawings of mine especially ones that you have altered with your made up cubit value.

Note to Mod’s if it is possible can you please remove this drawing of mine that Don has altered? [hallofmaat.com]



If not I understand.

RLH