Hi Alex,

Thanks for the detail on the angles.

In my model the following was on the drawing board for the revised design of the Bent Pyramid:

The cotangent of the revised lower slope on the south side of the Bent Pyramid is the seked of 5 palms which has a symbolic cotangent of 180/252 as (9 x 20)/(9 x 28).

The mean lower slope on the east-west axis of the Bent Pyramid is extremely close to the seked of 5 palms as is the lower slope of the south face of the pyramid.

A circle with a diameter of 252/2 cubits has an area approximately equal to the cross-section of a true pyramid with a base side length of 25,920/4 digits, and a seked of 7.5 palms.

The true pyramid sits on top of a truncated pyramid with a base of 360 cubits and a height of 90 cubits for the seked of 5 palms.

The projection of the true pyramid to the base level of 360 cubits is sr180,000 square cubits as its virtual base, compared to a side length of sr90,000 square cubits for the inner structure.

There is a geometric plan conforming to the proposed design in which a projection of the sides of the true pyramid at the seked of 7.5 palms strikes the edges of a natural grid at a level of 252 cubits below the peak of the true pyramid, and a pyramid with a height of 252 cubits and a slope of the seked of 5 palms has a base of 360 cubits.

In this plan an inner structure of 300 cubits has the same base level as the base of the Bent Pyramid.

Mark



Edited 1 time(s). Last edit at 02/28/2020 07:11PM by Mark Heaton.